Slitters | Sheet metal slitters | slitting machines

The Gary Model 3350 Superduty Sheet Slitter adds a new dimension to this quality line of multiple cutting equipment. To serve the processor of requiring a wide range of capacities plus superior cutting quality, the Superduty Slitter has added horsepower .. equipped with one 3/4 H.P. motor .. to supple the torque required to cut a wide range of metal thicknesses (16 gauge through 30 gauge) at operating speeds of up to 100 feet per minute. The aluminum-magnesium twist eliminators permit a knife arrangement for cutting strips as narrow as 1 1/2 " in width.

Standard Features of the Gary Model 3350 Superduty Sheet Slitter:

• 3" diameter cold - roll turned, ground and polished shafts mounted in dual wall ball bearings, lubricated for life series.
• cold rolled steel gauges on both sides permit left or right hand operation
• end frames are of aluminum-Magnesuim alloy using the exclusive Gary Torsion Tube Assembly for a lightweight rugged unit.
• Heavy gauge steel table with "T" bar reinforcement.
• One 3/4 H.P. gearhead motor available for either 110 or 220 volt single phase 60 HZ
• motors provided with thermal overload protection by means of an electrical motor starter.
• available in either 40,60,80, or 100 Feet Per Minute.
• Remote hand pendant for easy knife settings.
• stripper fingers provide for a twist-free cut.
• standard knives 3/4 " thick X 3 " I.D. X 5 " O.D. High - carbon or optional high - carbon high - chrome steel

  Contact us about any of these Gary Slitters

  Return to the Gary Machinery Sheet Slitter Page

  Return to the HVAC/ROOFING/SIGNS Page

  Return to the Home Page